Configuring parameters

The data set must contain two columns that will be used by the profile.

About this task

To configure parameters:

Procedure

  1. The first column defines the phase duration and the second defines the target number of iterations.

    For example:

    myTime myIterations
    30 50
    60 75
    120 100
    Note: If necessary, these columns could be added to an existing data set since the test configuration allows you to select the first column to use (for the phase duration).
  2. After choosing the test data set, select the column to use for the phase duration and the units of time to apply (seconds, minutes, or hours).

    Each row of data in the data set represents a test phase, and all phases are executed by default. However, a range of phases to execute can be specified by entering a comma-separated list of phases in the Execute test phases field.

    For example:

    • 1 executes only phase one.
    • 1,2,5,6 executes phases one, two, five, and six.
    • 1,10-20 executes phase one and phases 10 to 20 inclusive.