SCS TRN Command (LU 1)

You can change the operation of the SCS TRN command by adding a parameter to the [printers] section of the workstation profile (*.WS):
ATRN=Y
Transfers data that is controlled by the SCS TRN command to the printer driver without conversion. This parameter is the default for SBCS. In the cases below, this parameter is assumed to be ATRN=N.
  • The printer driver does not support PASSTHRU.
  • The printer driver supports the BANDING function.
  • BANDING=Y is specified in the [printers] section of the workstation profile (*.WS).

When you use a printer driver for which the PASSTHRU function is incomplete, sense code X'1003' is returned to the host system for the SCS TRN command.

This is the default value.

ATRN=N
Converts data that is controlled by the SCS TRN command and transfers the result to the printer driver. This parameter is the default for DBCS.
Note:
The SCS TRN command (LU 1) is available in PDT mode only.