DLUR_SUPPORT

   DLUR_SUPPORT = (
      @TYPE = ENUMKEYWORD
      @ENUM_LIST = (
        NORMAL = 0
        MULTI_SUBNET = 1
      )
      @DEFAULT = NORMAL
      @REQUIRED = 1
    )

The DLUR_SUPPORT parameter specifies the level of support for DLUR provided by the node. This field is ignored for LEN links. Valid values are:

MULTI_SUBNET

DLUR full multi-subnet is supported. Broadcast searches are not received. This value is valid only if the NODE_TYPE parameter is specified as END_NODE.

For end node or branch network node: DLUR is supported, but is not used to connect to a DLUS in another subnet. If multi-subnet operation is not required, you should use the MULTI_SUBNET value instead of NORMAL to reduce network traffic and congestion at the network node.

NORMAL

DLUR full multi-subnet is supported. Broadcast searches are received.

LIMITED (same as MULTI_SUBNET)

DLUR limited multi-subnet is supported.

	MULTI_SUBNET DLUR full multi-subnet is supported. MULTI_SUBNET DLUR limited multi-subnet is supported. This value is only valid if the NODE_TYPE parameter is specified as END_NODE. NORMAL DLUR full multi-subnet is supported.
	LIMITED DLUR limited multi-subnet is supported. MULTI_SUBNET DLUR full multi-subnet is supported. NO DLUR is not supported.

	The default is NORMAL.
	The default is MULTI_SUBNET.

This parameter is required.

If the REGISTER_WITH_CDS value is 1, then the DLUR_SUPPORT value is MULTI_SUBNET. Otherwise, set the DLUR_SUPPORT keyword to NORMAL. The default settings are REGISTER_WITH_CDS=1, REGISTER_WITH_NN=1, and DLUR_SUPPORT=MULTI_SUBNET. These settings result in better performance by reducing network locate traffic and congestion at the network node.