RIGHT primary command
You can use the RIGHT primary command
in:
- View or Edit
- A WebSphere® MQ selection list
In View or Edit, any display format apart from SNGL, the RIGHT primary command scrolls to the right of your data. (This command is not valid in SNGL mode.)
The amount (number of columns) scrolled is determined by either an optional parameter or, if no parameter is entered, by the amount indicated in the Scroll field.
Syntax
- n
-
- In View or Edit
- In CHAR, HEX or LHEX display format, scrolls right n columns. In TABL display format, scrolls right n fields.
- In a WebSphere® MQ selection list
- Scrolls right n columns.
- CSR
- Scrolls right to the cursor position.
- DATA
-
- In View or Edit
- In TABL display format, acts the same as PAGE. In other display formats, scrolls right one column less than a page of data.
- In a WebSphere® MQ selection list
- Acts the same as PAGE.
- HALF
- Scrolls right half a page of data.
- MAX
-
- In View or Edit
- In CHAR, HEX or LHEX display format, scrolls to rightmost column. In TABL display format, scrolls to the rightmost field.
- In a WebSphere® MQ selection list
- Scrolls to rightmost column.
- PAGE
- Scrolls right one page of data.
- Scroll field
- Scrolls right by the amount indicated in the Scroll field. This is the default if no parameter is used. Entering a parameter other than MAX in the scroll field changes the scroll field default. If MAX is entered, the scroll field reverts to the previous setting after the command is issued.
Availability
Available on all panels when the panel information cannot be seen within one screen. In particular, it is used in the following panels, to allow you to view data: