Enabling the Language Environment abnormal termination exit (IDIXCEE or IDIXCE64)

Fault Analyzer requires a Language Environment® (LE) abnormal termination exit,IDIXCEE or IDIXCE64, as an extra method of invoking Fault Analyzer to the MVS™ change options/suppress dump exit. To enable this exit, you must add it to the CEEEXTAN CSECT for Language Environment® using a sample member in the CEE.SCEESAMP data set. You will make the changes suggested in the sample member and then replace the following comment with the appropriate lines.

         <<< REPLACE THESE 2 LINES WITH A COPY OF CEEEXTAN
             AND OVERRIDE AS DESIRED  >>>

AMODE 31:

In a copy of the CEEWDEXT sample member, replace the comment with these lines:

         CEEXAHD        ,User exit header
         CEEXART  TERMXIT=IDIXCEE
         CEEXAST        ,Terminate the list

AMODE 64:

In a copy of the CEEWQEXT sample member, replace the comment with these lines:

         CEEXAHD AM=64  ,User exit header (AMODE 64)
         CEEXART  TERMXIT=IDIXCE64
         CEEXAST        ,Terminate the list

If more than one exit is specified in the CEEEXTAN list (for example, due to other similar third-party products also being used), then Fault Analyzer should be the first exit specified.

If an IPL of MVS™ is not planned as part of the Fault Analyzer installation, this exit can be activated as follows, depending on whether LE has been placed in LPA or not:

LE in LPA
Determine the data set name and load modules updated by the USERMOD from the APPLY job output and issue the command:
```
SETPROG LPA,ADD,MOD=(module-list),DSN=data-set-name
```
If one or more of the updated load modules are not in LPA, then continue with the instructions for "LE not in LPA" below.
Note: Remember to reissue the SETPROG command after the next IPL, unless the IPL is performed with the CLPA option.
LE not in LPA
If LE is not in LPA, it is assumed to be in LINKLIST. To activate the exit, issue the command:
```
F LLA,REFRESH
```
If you prefer to selectively refresh only the affected load modules, then you need to check the SMP/E APPLY output for the updated data sets and load module names, add these to a CSVLLAxx parmlib member using the LIBRARIES and MEMBERS parameters, and then issue the command F LLA,UPDATE=xx. Alternatively, use Data Set Commander for z/OS® to perform the refresh.

For general information about implementing an LE abnormal termination exit, refer to the Language Environment® Customization book.

CICS notes:

The CICS® version of the AMODE 31 LE exit, CEECXTAN, which is installed with sample job CEEWCEXT, is very similar to the IDIXCEE exit. If you are going to install both, make sure that you double-check that you have used the correct names and not installed the same exit twice.
There is currently no AMODE 64 version of this exit for CICS®.