Starting the launchpad
To install the product, start the launchpad program.
Procedure
Depending on the source of the product installation, follow
one of these procedures to start the launchpad program;
- If you are installing from the CDs, complete these steps:
- Insert the Setup CD into your CD drive.
Mount the CD drive.- If autorun is enabled on your computer, the launchpad program
starts automatically. If the launchpad does not start automatically,
complete one of these steps:
Run the launchpad.exe command, which is located in the root
directory of the CD.- Run the launchpad.sh, which is located in the root directory
of the CD.
- If you are installing from electronic disks that you downloaded
from IBM® Passport Advantage®, open a command
line, and change to the directory where you extracted the disk images;
and then at the command prompt, complete one of these steps:
- Enter RPT_SETUP\launchpad.exe.
- Enter RPT_SETUP/launchpad.sh.